Topland Industrial Corporation Limited
China Professional Manufacturer of Gauze Processing Machines
Add to Cart
GHG-992B Gauze drying combination machine
1. A-shaped frame→Gauge feeding frame→Flat wash tank→Two-bowl padder→Drum dryer→Photoelectric tracking car coiling system
2. Relevant technical parameters:
a. Nominal width of machine: 1800mm, the gauze width that the machine can produce is 30-67”.
b. Machine speed: (GHG-992 basic model) 0-160m/min for 16 stainless steel drying ovens in Ф570mm, and (GHG-992G high-speed model) 0-250m/min for 16 stainless steel drying ovens in Ф800mm
c. Max. coil diameter of fed gauze: Ф1760mm
d. Max. coil diameter of discharged gauze: Ф680mm
e. One stainless steel flat wash tank: 1800×600×750
f. Left and right pressures of bowl padder can be controlled respectively, and pressure indicator is equipped, linear pressure is 300N/cm, the padding residual rate of gauze is approximate 60%, driving bowl (stainless steel bowl), diameter of driven bowl (wrapped with nitrile butadiene rubber), bending roll, spraying pipe and safety device are set before nip. Excircle of padding drum is ground, and water flowing plate is set below to prevent splash of droplets.
3. The running speed should be regulated in the range of 50-250m/min, rise and reduction of speed are stable without interruption, and cable speedometer can display readings.
4. A-shaped frame can bear 3.5t and can operate safely, on which cylinder pressurizing device is mounted, bearing bush is used on batching shaft head support of A-shaped frame to guarantee convenience and safety.
5. Synchronous speed regulation via variable frequency is adopted for the machine, and pendulum elastic frame is used for tuning so as to effectively guarantee the gauze always operates at the status of constant tension, front and back linear speed of the whole machine is synchronous.
6. Both sides of the drying machine are enclosed by movable doors, and on the top steam and moisture exhausting device is set to satisfy the requirement of producing clean gauze and preventing drip, while front and rear parts of the drying machine are not enclosed in order to monitor running conditions inside the machine.
7. The drying drums should be able to withstand 4kg/cm2 steam pressure and 2.5-4kg/cm2 operating pressure. The drums are made of stainless steel and attached with certificate of inspection issued by national technical supervision department. At gauze feeding location the surfaces of 4 drying drums are coated with Teflon in favor of clean production, and bending rubber rolls and spreading rolls are equipped.
8. Advanced pressurized photoelectric tracking lap machine is equipped and can ensure uniform edge curling parts of discharged gauze (±1-3.5mm) so as to provide effective guarantee for saving cutting in subsequent working procedure. After lap formation by lap machine gauze is uniform, warps and wefts are straight without creasing, skewness and damages, the max. diameter of lap formation is 680mm.
9. Dimensions of the machine are all be metric size, high-quality steel products are selected, and stainless products are adopted for various shafts, drums and selvedge guider, etc.
